Click image to view full size image
The product perfectly combine heat conduction performance and compliance. It is special designed for the application of gap heat transfer. The product can fill the gap and improve the heat transfer ability between the heat generation part and heat radiation part. These soft interface materials can laminate with the mating surface with minimum pressure, thus make few or no stress on the mating parts.
Thermal gap pad has inherent adhesion features, dispense with adhesion layer, at the same time it can cover the microcosmic uneven surface so that make the mating parts full contact, thus improve the heat conduction efficiency. The thickness can be special customized according to the customer demand. You can also choose the products with adhesive film or single side viscosity.
Available Configurations:
Typical Applications:
Thermal gap pad has inherent adhesion features, dispense with adhesion layer, at the same time it can cover the microcosmic uneven surface so that make the mating parts full contact, thus improve the heat conduction efficiency. The thickness can be special customized according to the customer demand. You can also choose the products with adhesive film or single side viscosity.
Available Configurations:
- Standard size: 470×470 mm, can die-cut according to customers' requirements.
- Thickness available: 0.3~8.0 mm
- Can laminate with the adhesive film according to customer's demands.
| PROPERTIES | UNITS | 520 Series | TEST METHOD |
| Appearance | - | Grey | Visual |
| Thickness | mm | 0.30 to 8.0 | ASTM D374 |
| Thermal Conductivity | W/m·k | 5.2 | ASTM D5470 |
| Thermal Resistance |
@ 1mm, 20 psi |
0.35 °C·in2/W 2.25 °C·cm2/W |
ASTM D5470 |
| Hardness | Shore OO | 60 | ASTM D2240 |
| Flame Rating | - | 94 V-0 | U.L. |
| Dielectric Strength | KV/mm | ≥10.0 | ASTM D149 |
| Volume Resistivity | Ω·cm | ≥3.0×1013 | ASTM D257 |
| ensity | g/cm3 | 2.70 | ASTM D792 |
| Tensile Strength | psi | 50 | ASTM D412 |
| Elongation | % | 45 | ASTM D412 |
|
Compression Deflection (%, at given pressure) |
10 psi | 18 | ASTM D575 |
| 50 psi | 35 | ||
| 100 psi | 55 | ||
| Dielectric Constant | @1 MHz | 5.0 | ASTM D150 |
| Service Temp. | °C | -60 to 200 | *** |
Typical Applications:
- Desktop, laptop and peripherals
- LED solid state lighting
- Power source and UPS
- Electronic telecommunication equipment
- LCD and PDP flat panel displays
- Automotive electronic products, battery cooling
- Motor and engine controller
- Energy conversion device
- Mass storage device
- Vibration damp application